In this project, there are two
sections (transmitter & receiver) as shown in the block diagrams. The
instructions such as Left, Right etc are processed and are given by the person
by operating PC. So based upon input of PC the following output will be seen
i.e. left or right. In Transmitter Section, the instructions are delivered to
Zigbee transceiver from microcontroller which is connected to the PC. This information is processed and is sent to
the receiver section via wireless.
In Receiver Section, the
signals from the transmitter section are received by the Zigbee transceiver and
send to the controller as input. Controller will process this data and it will
control the Robot direction according to the instruction which is given at the
transmitter section. Then the Robot will move in that particular direction for
the given instruction. Similarly camera directions also controlled.
No comments:
Post a Comment